200-ft Conveyor for Skiing: (1200pph @ 160fpm at

• Top Drive consisting of a 11kw (15hp) Standard style drive structure w/ shaft-mounted gearmotor, 12-inch diameter driving drum, ABB VFD for 480VAC 60Hz 3-ph supply.
• Rotating Snow Brush powered by separate gearmotor.
• Drive drum hot air blower
• Rollback brake (drop-dog style) on drive drum.
• Highspeed backstop on Motor Tail shaft
• Remote mounted pedestal drive control cabinet, with extended motor leads and control pendant
• 24” (600mm) 400/3-ply belting
• “Blue-Eye” belt with w/ RS187 mechanical splices.
• “G”-Type galvanized 3m (~10’) long midsections w/ open-bottom frame and Superslide slider bed w/ belt edge guides. (qty. 19)
• 12-inch wide walkways w/ hinged walkways on both sides
• ‘Jumbo’ return terminal with Passive Hydraulic Tensioning, 1m (40”) stroke, 300 mm (12”) return drum, integrated surge reduction flywheel, hinged terminal covers, belt slip monitoring, and full controls.
• Low voltage control system with fault annunciation panel, self-monitoring redundant stop system, Pluto S46 monitored transition area safeties, and start warning tone. (UL / cUL listed)
• Hinged or quick removable panels for access to the Drive and Return Terminals from Top.
• 300 mm (12”) adjustable staging jacks for fine-tune leveling; 2 per 10-ft midsection.
• Basic Maintenance package that includes additional splice rods, Adam safety switch, proximity sensor, basic hand tools, and belt clamping & pulling device for splicing.
• Installation Advisor on site or via phone during construction, training of personnel
• Delivered DDP to Belleayre Mountain Resort, NY

………………………………………………………………………………………………………………………………………………………………….

200-ft “Evolus - M” Gallery Enclosure

Conveyor enclosure with a minimum of 2.22 m (7.2’) vertical clearance over belt and 2.02 m (79.5”) wide at the walkway edge and 2.37 m (93”) wide @ 1m above floor that begins and ends

just prior to each terminal.

• Clear 4 mm thick UV-resistant Polycarbonate conveyor panels
• Galvanized crossbeams with mounting brackets to existing Frame
• 1x Mid-Gallery Evolus M Sliding Door
• Fleece covered extended-width walkways that lay adjacent to the 12” wide walkways and extend to the Gallery wall with a grey fleece surface.
• Polished aluminum support frame arches every 2.0 m (6.6’) that are split in the middle for ease of transportation and installation (Qty 76)
• Metal Side Cladding that extends ~12” below deck level
• 300 mm (12”) adjustable staging jacks for fine-tune leveling; 2 per Arch.
• Hinged Solid End Doors with lockable latches (Top & Bottom).
• Modular construction
• Delivered DDP Belleayre Mountain Resort Parking lot

Gallery Options:

1. a) Evolus M Gallery Enclosure over Return terminals. Solid hinged end door located at

downhill end of return terminal.

1. b) Evolus M Gallery Enclosure over Drive Terminal. Solid hinged end door located at uphill

end of drive terminal. Includes ‘Expansion Cavity’ bump out to keep control panel inside

the enclosure.